MS GluePro bonds cattle hoof blocks quickly and strongly. Compatible with rubber, wood, and polyurethane blocks, it can be used in all weather conditions, and cures in just 30 seconds!
MS GluePro – Fast-Curing Strong Hoof Block Adhesive (Supplied with mixing tip)
MS GluePro is an extremely strong and fast-curing adhesive specifically developed for bonding shaving blocks applied to cattle hooves. This reduces pressure on inflammation, damage, or wounds on the hoof, allowing for faster and healthier healing.
Features:
Compatible with all hoof blocks: Can be used on rubber, wood, or polyurethane blocks.
All-season use: Can be safely applied in winter, summer, or all weather conditions.
Fast curing: Cures in approximately 30 seconds.
Excellent adhesion: Provides strong and lasting adhesion to the hoof and block.
Odorless: No unpleasant odor during use.
2-component polyurethane adhesive
1 cartridge provides 11–13 applications
Instructions for Use:
Dosing and mixing: MS GluePro should only be used with the dedicated dosing gun and mixing tips.
Application surface: The hoof and block must be clean and dry.
If necessary, you can dry the nails with a hair dryer or hot air gun.
Application:
Apply slowly and fluidly to the nail or nail block.
The adhesive takes approximately 30 seconds to fully cure; the nail block can fully support weight after 2 minutes.
User Tips:
Very little heat is generated during curing, so it will not disturb the animal.
Mixing tips combine the components in the correct proportions.
Adhesive shelf life: 10 months after opening, at least 1 year for unopened cartridges.
Store at room temperature, prevent freezing.
Application Steps:
Store the cartridge upright and keep it upright when opening.
Open the cartridge or change the mixing tip.
Squeeze slowly with the tip pointing upwards, continue until the cartridge is half full; air will escape from the cartridge.
Apply the adhesive to the nail or block with a fluid pump motion.
After the process is complete, store the cartridge with the tip pointing downwards, release the pressure in the gun; After 10 seconds, you can place the gun horizontally.
In the next exercise, continue from step 3 as there will be no air in the cartridge.